Paw-Taw-John Services Logo

Resaw Systems

Provider for Cleereman Carriage Systems

Resaw Systems Flyer

Features

  • Linebar sets 1 through 16 plus left/right jog
  • Four species size tables
  • Easy calibration
  • Since a PLC is used, customer specified machine control is possible. An example, manual and auto roll sequencing
  • Enclosures and consoles are UL inspected
Saw Controls
  • Servo SensorĀ® motion controllers mounted in linebar hydraulic cylinders.
PLC Touch Screen Features
  • Run screen displays status of saw axis, real time position, target position, trouble messages, board selected, and many other features
  • Board sizes, operational limits, Servo dynamic values, servo limits, etc. are entered through the touch screen display and saved in the PLC battery backup ram.
  • Help menus for trouble shooting if necessary are on the touch screen
  • Some operational features are displayed on the help screens
  • Input/output status is displayed on the I/O screen. Servo SensorĀ® status is displayed on screen
  • Timer entries for roll sequencing
  • The run screen will also show a trouble message if a problem occurs with the system
System Hardware Features
  • The system control cabinets, operator panel, and j-boxes are pre-wired at the factory
  • All cables are labeled and cut pigtails are left at the terminal blocks of each enclosure
  • Rewiring of the enclosures is expedited because the colored wires and pairs are left as they were when tested at the factory
  • Each enclosure has an identifying placard on the front of it
  • The operator console overlay is reverse engraved, to prevent wear and tear over the years of operation
  • An interconnect cable diagram is provided as well as an installation/operation manual
  • The manual is written to cover most operational procedures and installation requirements
  • Resaw control hardware
Operator Panel
  • All inputs and outputs within panel are +24VDC
  • LED lamps used within the lighted push buttons for longer MBF
  • Lighted E-Stop and control power buttons
System Hardware
  • The system control cabinets, operator panel, and j-boxes are pre-wired at the factory
  • All cables are labeled and cut pigtails are left at the terminal blocks of each enclosure
  • Rewiring of the enclosures is expedited because the colored wires and pairs are left as they were when tested at the factory
  • Each enclosure has an identifying placard on the front of it
  • The operator console overlay is reverse engraved, to prevent wear and tear over the years of operation
  • An interconnect cable diagram is provided as well as an installation/operation manual
  • The manual is written to cover most operational procedures and installation requirements

Resaw Controls